U-Band wireless microphoness indicate that they can accept U-Band microphoness. U-Band wireless microphoness generally refer to 30-3000mhz communication. U-Band wireless microphoness are suitable for families or small conference rooms. The ability to receive signals is stronger than that of V-band wireless microphoness. However, the number of wireless microphoness should not exceed four to avoid affecting the signal acceptance ability.

Precautions for equipment application: 1. Keep the U-section wireless microphones clean to avoid affecting the radio ability of the equipment. When using, do not hold the net head of the microphones by hand, which will affect the radio function.

2. Do not disassemble the U-section wireless microphones by yourself, which may cause other problems of the microphones. It is recommended to contact technical personnel for maintenance.

3. The U-section wireless microphones cannot work. It is suggested to check the power utilization status and use it after charging for a period of time.

4. The radio ability of u-segment wireless microphones is low. It may be that there are too many signal interferences nearby, including Bluetooth signal. If the reception environment is too poor, you can use wired connection.

Advantages of u-segment microphones:

Anti interference can be strong: because the frequency range of V band is narrow, more than 6 will interfere with each other, while u band has a wider frequency range, and there will be interference in more than 60.

Good stability: v-segment microphones has poor reception effect, and the signal often stops, while the u-segment microphones can receive strong and stable signal.

High technical content: the u-segment is high-frequency emission reception, so its own requirements for electronic components are higher than that of v-segment, and the technical content is also much higher.

Convenience in practical use: most of the current u-segment can be used for FM function. If a KTV occasion uses a u-segment wireless microphones, then it can be equipped with several hands in this band as backup. If there is a problem, change the spare one to the frequency point of the original one, and it will work normally immediately. If it is a microphones with V segment, it will be troublesome. V segment can not be FM. In this case, only the same frequency point can be used. If KTV has 30 sets to use, then 30 sets of standby are needed, which is unrealistic.

Source: Enping Microphones https://www.liyangpro.com/